BG223118341
- mon contenu
- Tous les messages
- Commentaires
- Commentaires
- réponses
- Questions
réponses
BG223118341 I do not believe that they sell new chains however, others do and they will fit.
Utile (0)
Q: This product exists in a larger size, a few kg load capacity?
demandé par Chariot sur 2021-04-04 06:47:18
BG223118341 Yes it does. On Eleksmaker,s site.
Utile (0)
Q: Does anybody know how this works, can't see directions or instructions.
demandé par BG361211134 sur 2021-03-10 14:38:03
BG223118341 They have a video on how to use this product. I believe it is at the bottom of the page where the tools arew.
Utile (1)
BG223118341 You may get away with corner brackets or end plates.
Utile (0)
BG223118341 I can `t see why not, if your board can handle the amps and you watch orientation of the A+ A- B+ B- (red blue green black).
Utile (0)Q: Hello, do I have a question? Is it a compatible with Atomstack A5 - 20W? Thank you for answer.
demandé par BG114252315 sur 2021-02-04 09:11:43
BG223118341 I am not an expert on Atomstack A-5, however the #17 stepper motor uses 1.3 amp to operate. You may need a 4th axis to run the elecks rotate. If the steppers on the Atomstock are #17, I do not see a problem. If the Atomstack uses 2 steppers, then you will need a board that drives 3 steppers.
Utile (0)
Q: will this rotary unit work with the neje master master 20w laser engraver?
demandé par damnnoid sur 2021-01-28 08:31:00
BG223118341 The rotation is done by the stepper motors, which get their signal from the stepper drivers. The laser is controlled on its own from the board. I hope this is of some help.
Utile (0)
BG223118341 4mm would be about right and you can but it at any hardware store. Tell them it is for a chainsaw.
Utile (0)