Meilleures offres pour Lunettes FPV,Caméra FPV,Microscope

demandé par sqfoofs sur 2018-09-27 09:38:50

Tyburn Yes you be able to put RHO lenses, on thé ev200d you can put fatshart gifle

2020-02-07 02:29:36 Utile

Soumettre

réponses (1)

sqfoofs 16/10/2018

I have not really flown with this yet - only plugged it and tried a few things in to check that it works. The camera works well and I am happy with it so far, but before you plug it in to ANYTHING, check the wires in the plug. Mine were completely reversed from what the picture and documentation show. I did a little research and thanks to another helpful post here, I was able to carefully pull the wires out of the plug and re-insert them in the correct order for my aurora 1000. Video works, OSD works. I can understand that this is not the exact replacement for the original camera in the Aurora 100, but the wires were not even in the same order as the documentation and photos - you can't trust that you can just plug it in to whatever it is intended for. 3 stars for quality - the camera works well, but no one should have to double check and change the wiring of a product. Unless you pay attention to the wires and check them carefully, you could ruin something just by plugging this in.

Eachine TX05 0.01/5/25/50/100/250mW commutable avec OSD AIO 5.8G 72CH VTX 600TVL NTSC Mini caméra FPV pour drone RC

32,28€ 59,96€

1

Commentaires (0)

sqfoofs 28/02/2019

just got this - seems to work well. + Charges with just the USB so don't worry about getting the european adapter - you don't really need it. (FYI you can not operate it while the USB is plugged into the computer - I haven't tried the software that was linked in one of the questions) + The stand seems solid and the anti-slip pads on the bottom are good, but it would be nice if the base was a little larger, but that's not a problem. + provides more than enough magnification for me to solder tiny stuff, even with the optics raised as far away as possible from the stand (approximately 12 cm). + there's plenty of room under it to solder stuff and it's MUCH better than wearing the jeweller's magnifier that I have been using. + the depth of focus is shallow but not too shallow (so it's good!) + The focus knob works well - focus and resolution are quite good for using this to do small work + I like that the light can be adjusted and even turned off to allow use of other light sources like natural light or a desk lamp + for versatility, you could easily find a way to mount the unit on a different stand if you really wanted to (haven't tried it, but maybe using one of those third hand tools or something...? the screen/lens unit weighs about 180 grams) Overall - comparing this to jeweller's glasses/magnifier for around the same price (the kind that you wear), this is better! way more comfortable, less finicky and works well!

G600 numérique 1-600X 3.6MP 4.3 pouces HD LCD affichage Microscope loupe continue Version de mise à niveau

59,67€ 62,73€

0

Commentaires (0)

sqfoofs 28/02/2019

ok

Module convertisseur automatique Geekcreit® DC-DC Boost Buck réglable pas à pas XL6009 adapté aux panneaux solaires

6,45€ 8,29€

0

Commentaires (0)

sqfoofs 16/10/2018

good

Eachine Aurora 90 paquet de vis de pièce de rechange de kit de cadre de drone de RC de mini FPV Racer

7,45€ 8,29€

0

Commentaires (0)

sqfoofs 16/10/2018

good

Eachine Aurora 100 Mini Sans Balais FPV Racer Drone RC Kit de Cadre Pièce Détachée d'Ensemble de M2*6 Vis

6,38€ 7,37€

0

Commentaires (0)

sqfoofs 01/10/2018

dense foam, works great, fits on my Q X7 perfectly and works well. Very simple and does the job well. I use them with this case: https://www.banggood.com/Realacc-Zipper-Handbag-Hard-Case-For-Frsky-X9D-FlySky-i6S-i6-DJI-Transmitter-p-1098445.html?

2 PCS EVA Transmetteur Protection des Gaz Éponges Compatible FUTABA JR Frsky Flysky pour RC Drone

1,88€ 2,85€

0

Commentaires (0)

sqfoofs 01/10/2018

mine came with one big block of foam that was perforated. No problem pulling out little bits to make it fit my Q X7 perfectly. The inside pocket is great for the small stuff. get some of these to protect your sticks: https://www.banggood.com/2-PCS-EVA-Transmitter-Throttle-Protection-Sponge-Compatible-FUTABA-JR-Frsky-Flysky-for-RC-Drone-p-1243954.html?

Realacc Étui Dur Sac à Main Zipper pour Transmetteur Frsky X9D FlySky i6S DJI à Télécommande

18,63€ 29,52€

0

Commentaires (0)

sqfoofs 26/06/2018

simple use. voltage reading matches my voltmeter, so I assume it's accurate!

Testeur de tension de batterie Moniteur de batterie Alarme à buzzer pour batterie 1S-8S Lipo

7,42€ 10,14€

0

Commentaires (0)

sqfoofs 20/06/2018

works well

RJXHOBBY 4pcs Ruban Adhésif Antidérapant en Silicone de 250x30mm pour Drone de Course FPV

17,04€ 18,44€

0

Commentaires (0)

sqfoofs 20/06/2018

I have been using this without any problem. Works well on my 2S batteries with my Hitec chargers

Carte de charge parallèle 1S-3S XT30 Plug Para Board pour chargeur B6

13,78€ 14,75€

0

Commentaires (0)

sqfoofs 15/03/2018

very thin - you need to be careful not to drop or hit them because they will break.

100pcs N50 Disque Rond 12 x 1mm Aimant Rare Earth Magnétique Jouets Magnétiques

8,05€ 9,66€

0

Commentaires (0)

sqfoofs 15/03/2018

as expected. strong magnets. The hole and countersink is just right for small screws.

4pcs N52 20 * 5mm trou 5mm aimant néodyme super puissants

9,12€ 10,14€

0

Commentaires (0)

sqfoofs 16/02/2018

I bought this to play around with making simple experimental foamie planes. I have a Taranix qx7 and managed to bind with this using the iRange IRX4 Plus module. It seems to work just fine, responds as expected. no issues. There are a lot of videos out there about how to bind various radios with this, but I suspect most of them are confusing linking with binding (typically, you bind once and from then on, you link which happens when you turn things on) If you are having trouble, it BINDS when the red light is flashing rapidly. the IRX4 is in bind mode when its red light is flashing. you need to coordinate this so that the v911 is flashing rapidly while the module is also flashing. It requires timing and it is tricky, but it does work.

WLtoys V911 V911-1 V911-PRO V911-V2 Pièce Détachée de Carte PCB pour Hélicoptère RC

10,04€

0

Commentaires (0)

sqfoofs 16/02/2018

as described. not much more to say

Ensemble combo de moteur CW sans noyau 0720 + hélice pour avions de modèles RC DIY Parkfly

6,27€ 12,17€

0

Commentaires (0)

sqfoofs 15/02/2018

It comes with instructions that are translated well and it's easy to set up a model and bind. It fits perfectly in my taranis x7 and looks good and appears to be made well.

iRangeX IRX4 Plus 2.4G CC2500 NRF24L01 A7105 CYRF6936 Module TX ARM multiprotocole 4 EN 1 avec boîtier

29,51€ 62,73€

0

Commentaires (0)

sqfoofs 01/02/2018

These will flex a bit but they are half the weight of the aluminum circular guards and they leave PLENTY of room for the props. Mine haven't broken yet.

Garde-hélice 4 PCS Everyine pour Aurora 100 Mini FPV Racer 1102 1103 1104 1105 Moteur sans brosse

6,45€ 8,29€

0

Commentaires (0)

sqfoofs 01/02/2018

they don't flex much at all and feel sturdy, but they are quite thin. If you need to bend them back several times, maybe that thin aluminum might fatigue, but these seem to be sturdy enough (they are twice the weight as some of the plastic guards but still relatively light). You might not want to put these on one of those super thin frames because I suspect they would transfer the energy to the frame due to their stiffness. On the other side, a light to moderate crash isn't going to bend these into the props. I had some success mounting these to the Eachine Aurora 100. They leave just enough room for the props. If they were flexible plastic, I would say not enough room but these do not seem to flex. However, to get the mounted I had to put the front guards underneath of the frame and the back guards on top, between the frame and motor. it means the back motors will be 1mm higher if you try that. They just touched doing that but seem to be ok. I didn't keep the configuration long enough to really test it well. They are strong, they look great but I put Value for Price lower because they are more than 4 times the price of the plastic guards...but maybe you think that doesn't matter.

PG50 Protecteur de protection à hélice de 2 pouces 50 mm Compatible avec le moteur 1102/1103/1104/1105

2,76€

1

Commentaires (0)

sqfoofs 01/02/2018

same as the original. I had to replace one that seemed to be shorted. I think I found the problem with the old motor after I replaced it. New one works fine

DYS BE1102 7800KV 10000KV Moteur Brushless pour RC Drone FPV Racing

10,14€

0

Commentaires (0)

sqfoofs 01/02/2018

Edges are smooth and it comes with extra motor screws. no complaints. That's all I can say because I have not installed it yet - I will when I smash my original! (what can I say...I'm clumsy and I know it will happen)

Eachine Aurora 100 Mini sans Balai FPV Racer Pièce de Rechange 2mm 2.5mm Plaque de Fond 3K en Fibre de Carbone

13,84€ 14,75€

0

Commentaires (0)

Bienvenue sur Banggood,

Vous autorisez:

Tous les messages

Vous êtes l'expert, pouvez-vous aider?

À propos des badges

About Badges

Helpful Badges

Are you ready to help?