BG153254234
Jacques Effectively, I observed that this clone board can be programmed with the Arduino IDE using the TX and RX pins and a Serial TTL USB converter when powered by an external battery (1S here) : just maintain the PRG button pressed (or connect GPIO 0 to GND) and press quickly the RST button when "Connecting..." is displayed. After the message "Hard resetting via RTS pin", the PRG button can be released and just press quickly the RST button to run the sketch. But may be better to obtain a TRUE HELTEC board !
2019-11-02 11:40:39 Utile (3)
Odontist N/O N/C
2018-11-29 12:58:00 Utile (0)Nous vous invitons sincèrement à vous abonner à l'e-mail d'invitation à répondre!
Si vous vous abonnez, nous vous inviterons par e-mail à répondre aux questions des gens sur les produits. En vous abonnant, vous gagnerez également le «Badge utile»! Vous pouvez vous désinscrire à tout moment sur la page des paramètres de confidentialité.
Aidez les autres et soyez plus heureux!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
.JPG)
Yogurt It's NC.
2018-11-13 08:27:56 Utile (1)