Tous les messages

Q: Is 5v pin output or input ?

demandé par Dhrumil sur 2018-12-28 06:16:48

Kahikatea https://img.staticbg.com/images/oaupload/banggood/images/4E/38/202a38e8-7330-4f41-81d1-f7df4ba3146f.jpg

2019-01-04 03:47:03 Utile (2)
Soumettre
réponses (2)

polypagan esp32 has 2 adc's each of which has an analog mux on input (like Uno). this board had 6 analog input in usual location. on digital side, pins go rxd, txd, gpio26 (dac2), 25 (dac1), 17, 16, 27, 14, then 12, 13, 5, 23, 19, 18. followed by gnd, rst, sda, scl.

2019-09-09 01:03:45 Utile (2)
Soumettre
réponses (3)

holdenweb Any wall wart should do - the Mini needs less than a fifth of an Amp as I recall. It regulates the 5v from the wall wart down to 3v3 to drive the ESP8266, so digital interface logic should operate at 3v3 unless you want to use level converters. The analogue input pin A0 won't tolerate more than 3.2v so treat it gently.

2019-05-29 02:39:39 Utile (1)
Soumettre
réponses (2)

Q: Is it work with wemos d1 mini v2.2.0 ?

demandé par Dhrumil sur 2019-04-10 07:28:05

Tamper2 not test with that, maybe you can try

2019-04-18 08:42:41 Utile (0)
Soumettre
réponses (1)

Q: can you give power supply product link ? where to buy ?

demandé par Dhrumil sur 2018-07-28 12:37:23

Karmen Maybe you can find it in "Electronics-Arduino Compatible SCM&DIY Kits" Category.

2018-08-01 08:13:22 Utile (0)
Soumettre
réponses (1)