hansakj
mon contenu
Tous les messages
Commentaires
Commentaires
réponses
Questions

Tous les messages

jinantha 19/08/2019
Fast shipping. came in good packaging. unit worked as described. bought it to power a LCD 32 inch TV. Original power pack was lost. Worked like a charm. durability, not sure for how long.
Adaptateur d'alimentation AC/DC ajustable Excellway 4-24V 2.5A 60W avec contrôle de vitesse et affichage de tension. Prise EU/US/AU/UK.
10,28€ 18,63€
0
Recommandations
Commentaires (0)
jinantha 19/08/2019
Fast shipping. arrived in good packaging. nothing was broken. Ordered to because a one of my LED torch 18560 battery charging unit broke. with this i retrofit a separate charger for the battery. worked like a charm and still working after 3 months of use.
Module de charge de batterie au lithium TP4056 Micro USB 5V 1A avec protection TE585 chargeur Lipo 5Pcs
6,65€ 9,31€
0
Recommandations
Commentaires (0)
jinantha 27/12/2018
Good build quality. I would recommend to anyone.
10pcs ABEC-7 608ZZ 8x22x7mm Paliers à Billes à rainure Profonde Paliers à Billes
8,57€ 9,31€
0
Recommandations
Commentaires (0)
jinantha 23/12/2018
I received today 23-Dec-2018. Wire is not silicon as advertised. It is normal plastic casing.
10 Pièces 2,54XH 22AWG 13CM 2S 3Pin Câble d'équilibrage en fil de silicone pour batteries Lipo
7,45€ 16,77€
0
Recommandations
Commentaires (1)
jinantha 29/08/2018
The display I received works for 30 minutes and then goes off. I had another display from another supplier and it is working till date. So I recommend you to buy from Sparkfun, Adafruit or ebay where they give good service. They will replace your products or refund you back. But here, too many questions and and they forget about it.
5110 LCD Module d'affichage rétroéclairage blanc
8,57€ 9,31€
0
Recommandations
Commentaires (1)
jinantha 08/07/2018
I highly recommend. solid build and quality plastics. not difficult to remove battery.
5pcs DIY 1-Slot 18650 Support de Batterie avec Broches
6,14€ 7,45€
0
Recommandations
Commentaires (0)
jinantha 08/07/2018
I highly recommend this cable. Build quality is supper and works without any issue.
BlitzWolf® AmpCore BW-TC5 3A USB Type-C Câble de Données de Recharge Tressé 3.33ft / 1m Avec Bracelet Magique
8,57€ 9,31€
0
Recommandations
Commentaires (0)
jinantha 06/07/2018
I would buy again. Plastics is strong. But very difficult to remove battery once inserted.
Boîtier de pile DIY de 5 pièces pour batterie rechargeable 18650
5,35€ 6,52€
0
Recommandations
Commentaires (0)
jinantha 06/07/2018
These modules does not work properly. Over charge the battery. Uses a fake TP4056 chip on them, not the original NanJing Top Power TP4065. Original chip https://lcsc.com/product-detail/PMIC-Battery-Management_TP4056_C16581.html
5Pcs Micro USB TP4056 Module de protection de charge et de décharge Protection contre le surintensité à courant excessif 18650
9,68€ 10,24€
0
Recommandations
Commentaires (1)

jinantha Good review Thanks

BG233251525 05/03/2018
This board will probably provide adequate power for a Raspberry Pi 3 provided any additional hats, etc consume virtually no power. I plugged the board onto a Raspberry Pi 3 and plugged it into a 5v power supply and allowed the battery to fully charge. I attached a low power USB drive and then booted into Raspbian with a monitor, mouse and keyboard attached. It booted but I kept getting the low voltage warning on the monitor. I checked the power consumption of my set up by attaching it to a bench power supply and it was just under 2 amps, so the UPS hat should have been able to cope. I then took an oscilloscope to the 5v supply coming from the UPS to the Raspberry and found that it was spiking below 5v. I then disconnected the UPS from the Raspberry and power supply so that it was running purely from the battery. I simulated a load of 0.5A / 500mA as shown in photo (1) at which point the 5v supply had a 100mV ripple but averaged about 5.2v as seen photo (2). I then simulated a load of a little less than 1A (actually 918mA) as shown in photo (3) at which point the ripple became slightly increased and the average voltage dropped to 5v as shown in photo (4). After a few seconds negative spikes started to appear as in photo (5) which I think would be enough to trigger the under voltage warning on the Raspberry and potentially cause issues. To summarize, I would not rely on this board to power anything more than just a bare Raspberry.
Geekworm UPS HAT Conseil + 2500mAh batterie au lithium pour Raspberry Pi 3 modèle B / Pi 2B / B + / A +
18,52€ 19,04€
11
Commentaires (2)
jinantha 18/06/2018
Fast shipping and item arrived in 5 days. Happy with them as i can see they are quality product.
3400pcs 170 valeur 0805 smd kit de résistance 0r ~ résistance 10MR 1 / 8W 5%
16,40€ 18,63€
0
Recommandations
Commentaires (0)

Vous êtes l'expert, pouvez-vous aider?

Nous vous invitons sincèrement à vous abonner à l'e-mail d'invitation à répondre!

Si vous vous abonnez, nous vous inviterons par e-mail à répondre aux questions des gens sur les produits. En vous abonnant, vous gagnerez également le «Badge utile»! Vous pouvez vous désinscrire à tout moment sur la page des paramètres de confidentialité.

Aidez les autres et soyez plus heureux!

  • S'abonner

À propos des badges

Les badges sont liés à la communauté et les utilisateurs le font en créant un contenu de qualité, en complétant des missions ou en participant à des activités spéciales. Les personnes spécifiques auront également leur propre badge exclusif.
Badge du PDG

L’insigne du PDG appartient uniquement au patron de Banggood.

Les badges que vous pouvez gagner arrivent bientôt
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe