Tous les messages

Q: Can you extract the battery?

demandé par Roberto sur 2021-09-25 08:02:54

sfromis My experience is that the battery pack can be swapped, if you fold the bike and turn the key under the battery an extra step while pushing it.

2022-01-24 11:20:53 Utile (0)
Soumettre
réponses (4)

Q: Can i use this for my mitsubishi montero 2014 model?

demandé par rodolfoduruin3 sur 2019-08-24 07:31:15

sfromis Very unlikely, that would be atrocious security.

2020-01-24 06:43:48 Utile (0)
Soumettre
réponses (2)

Q: Are these pass through plugs or butt stop at end of plug??

demandé par jammy5152 sur 2020-01-06 06:18:56

sfromis No pass through.

2020-01-16 03:29:03 Utile (0)
Soumettre
réponses (2)

Q: Will it work w/ 110V?

demandé par abnatal sur 2019-12-09 09:14:32

sfromis You should not expect it to work, as the specifications says 220-240V. Anyway, I would not expect the lower voltage to be found in outlets with around 230V, which the prongs match. 110V outlets are physically different.

2019-12-14 01:53:07 Utile (0)
Soumettre
réponses (4)

Q: Is it possible to modify the I2C adress

demandé par payettep sur 2018-08-28 01:34:03

sfromis Using the solder jumpers near the same edge as the INT pin, you should be able to choose between I2C addresses 0x29, 0x39, or 0x49 by bridging the center pad to either L or H.

2019-06-13 11:15:21 Utile (0)
Soumettre
réponses (2)

Q: how to assemble all parts into a single i.e into operation...

demandé par Abhishek Kangokar sur 2018-02-11 04:52:09

sfromis You'll have to buy a battery separately, and solder wires from the circuit board to both solar panel, battery and LED module, all with the appropriate polarity.

2019-03-12 12:41:50 Utile (0)
Soumettre
réponses (1)

sfromis Full charging capacity needs more than the power level provided by many USB ports, often somewhere from 500-1500 mA, if at all. I'd expect it to still charge at lower speed, but charging 4 batteries from 500 mA can be really, really slow.

2018-10-24 09:27:16 Utile (1)
Soumettre
réponses (3)