Tous les messages

Q: does it have 24v supply also?

demandé par johngs sur 2021-04-30 01:50:01

matthijs it has soldering pads for either a 12 v input or a 24 v input

2021-12-21 09:16:13 Utile (0)
Soumettre
réponses (2)

matthijs its an ER 11 Collet chuck, the one included, i believe is 5 or 6 mm, not sure. Before the first cut, CHECK YOUR ORIGIN, by that i mean, check where your machine has its zero set. Also check if the machine can travel the extent of your cut file. Keep in mind this machine has NO HOMING SWITCHES and wil absolutely slam into its own frame without having the slightest idea anything is wrong, so supervise it.

2021-11-17 09:44:42 Utile (0)
Soumettre
réponses (4)

Q: is this pnp with ender 3 v1 ?

demandé par pilotgenteng sur 2021-01-09 11:13:03

matthijs theender 3 stock control board does not support servo outputs, wich is needed. you can, however, change your control board. But that is quite a lot of trial and error to get everything configured right

2021-03-25 07:50:22 Utile (1)
Soumettre
réponses (2)

Q: can be used with lipo 3s battery ?

demandé par Fabian Negrin sur 2020-03-11 11:00:57

matthijs youcould, but i recommend using a battery protection board

2021-03-25 07:48:47 Utile (0)
Soumettre
réponses (2)

Q: Is it possible to switch the keys with other switches?

demandé par Greendragon sur 2018-04-16 09:33:17

matthijs nope

2021-03-25 07:48:07 Utile (0)
Soumettre
réponses (1)