Aresby
mon contenu
Tous les messages
Commentaires
Commentaires
réponses
Questions

Tous les messages

Aresby 14/04/2019
I did a video on this great little screen for which there is a modified Adafruit library available. https://youtu.be/TKN9WmunCQU
3Pcs Geekcreit® Écran OLED V2.0.0 pour Wemos D1 Mini de 0.66" Pouces 64X48 IIC I2C Deux Boutons
15,65€ 22,36€
2
Recommandations
Commentaires (0)
Aresby 21/07/2020
Not really suitable for CR2032 as the battery is so thick it eventually (after a few days) forces the soldered metal holder off the PCB (including the pads). I found that using CR2025 is a much smoother (less stress) fit. A CR2016 might work too but I haven't tested that. The small switch is nice but dainty, I don't expect to pass much current through it.
5 pièces LilyPad porte-pile Batterie CR2032 Batterie module de montage
8,56€ 10,24€
0
Recommandations
Commentaires (0)
Aresby 21/04/2018
Connect an approx 3K3 resistor from CH_PD (Chip Enable) to VCC to enable the chip. Also, connect approx 1K5 from GPIO0 (zero) to VCC to allow it to run from the bootloader. Then it works. The manufacturer cannot ever have tested this module. Easy to fix but rather untidy finish now with two resistors soldered underneath. Still reasonable value for money but the quality is obviously poor (as is the soldering of the sockets on this module, all over the place).
Module de relais ESP-01S WiFi Smart Remote Switch Phone APP Geekcreit pour Arduino - produits compatibles avec les cartes officielles Arduino
3,72€ 10,24€
2
Recommandations
Commentaires (1)
Aresby 31/01/2020
This had the long metal screws to hold the screen to the front panel, good!
Boîtier en acrylique à coque transparente pour 128X64 0,96 pouces OLED LCD support de module d'affichage à LED
2,79€ 7,45€
0
Recommandations
Commentaires (0)
Aresby 31/01/2020
No problems with this item.
Module d'affichage Geekcreit® 0,96 pouces 4 broches bleu jaune IIC I2C OLED Geekcreit pour Arduino - produits compatibles avec les cartes officielles Arduino
5,35€ 11,17€
0
Recommandations
Commentaires (0)
Aresby 14/04/2019
For custom circuits as part of the Wemos D1 mini setup these are great. It's the one with the LED on in the photo. See my video here: https://youtu.be/TKN9WmunCQU
Carte d'extension de bouclier 5Pcs ProtoBoard pour D1 Mini Plaque de Perf double face compatible
6,64€ 9,31€
0
Recommandations
Commentaires (0)
Aresby 23/04/2019
Fantastic for video YouTube videos. You can place one either side of you to get a balanced (and bright) light. Just plug directly into your household electricity (mains) and that's it. They get fairly warm after some time but nothing to worry about. They are very bright.
Lampe de jardin étanche à LED 50W coque noire avec éclairage blanc pour l'extérieur AC185-265V
18,28€ 19,56€
0
Recommandations
Commentaires (0)
Aresby 14/03/2019
This is really professional looking equipment box and will make any electronics project very good looking. The front and rear plastic panels are easy to cut with care for cables, switches, panel meters etc. The trick is to do it slowly and gently, you can always cut away a bit more but not put the plastic back! The handle swings forward to tilt the front panel upwards to make it easier to see. It then swings underneath to make the case flat to the workbench again.
Excellway® EF01 Coque en Plastique Electronique Cartouche Poignée Etui Projet d'Instrument de Bureau 200x175x70mm
17,14€ 18,63€
0
Recommandations
Commentaires (0)
Lampe de jardin étanche à LED 50W coque noire avec éclairage blanc pour l'extérieur AC185-265V
18,28€ 19,56€

Q: What type of connection is required for direct wiring to American 110-115 voltages?

demandé par pennington2008 sur 2019-01-19 08:06:30

Aresby You could wire two in series, that would work for USA voltages.

2019-01-19 10:37:46 Utile (0)
Soumettre
réponses (2)
Aresby 14/03/2019
Makes a huge difference when soldering (or desoldering using braid). It allows the solder to wet the track so much more easily. Only minor problem is that the tip eventually (after 1 year) becomes a soggy clump which is why I'm ordering another one. Definitely worth it.
Stylo Kester-186 avec flux de colophane FPC PCB outils de réparation de soudure pâte à souder
10,75€ 11,17€
0
Recommandations
Commentaires (0)
Aresby 14/03/2019
A tiny sewing machine that is perfect for simple stitches (eg hems). Just an hour's practice will enable you to produce good results. Footswitch is just on/off, no speed control. Just what I needed to resize my Green Screen that I use for YouTube videos, simple hem, perfect. This might be very small but it is not a toy, it is a proper sewing machine.
Machine à coudre électrique de maison de bricolage portable avec la lumière menée
40,71€ 42,86€
0
Recommandations
Commentaires (0)
Aresby 14/04/2019
Powerful chip on a tiny board. See my video here: https://youtu.be/TKN9WmunCQU
3pcs D1 Mini V3.0.0 WIFI Carte de développement Internet des objets basée sur ESP8266 4MB Geekcreit pour Arduino - produits compatibles avec les cartes Arduino officielles
17,21€ 18,63€
0
Recommandations
Commentaires (0)
Aresby 14/04/2019
Easy to use, just plug in. Can use longer or different type-K thermocouples (available here on Banggood).. See my video here: https://youtu.be/dRGX_8P_98w
LED rouge DC 12V Thermomètre à thermomètre numérique Thermomètre 0 ~ 999 ° C avec sonde
23,67€ 25,15€
0
Recommandations
Commentaires (0)
Aresby 14/04/2019
The dual and triple boards are great to create a Wemos D1 mini project. See my video here: https://youtu.be/TKN9WmunCQU
3Pcs Double prise double base Shield pour D1 Mini NodeMCU ESP8266 DIY PCB D1 Carte d'Expansion
8,60€ 9,31€
0
Recommandations
Commentaires (0)
Aresby 14/04/2019
Easy to interface using SPI and the Wemos D1 Mini See here: https://youtu.be/TKN9WmunCQU
3Pcs Micro SD Shield pour Module WiFi ESP8266 SD D1 Mini TF sans Fil
7,52€ 8,38€
0
Recommandations
Commentaires (0)
Aresby 14/04/2019
Great way to power the Wemos D1 mini boards See my video here: https://youtu.be/TKN9WmunCQU
3Pcs WeMos® DC Power Shield V1.0.0 pour WeMos D1 Mini
15,06€ 15,83€
0
Recommandations
Commentaires (0)
Aresby 14/04/2019
The triple base is a great start for a project so that it doesn't turn into a towering monster! See my video here: https://youtu.be/TKN9WmunCQU
3pcs Wemos® Tripler Base Socket V1.0.0 pour WEMOS D1 Mini
10,75€ 11,17€
0
Recommandations
Commentaires (0)
Aresby 14/04/2019
I bought two pairs and they are very, very sharp. Far less pressure is required when using them. they must be good because the price has gone up by $1 since I bought mine!
Meilleures pinces coupantes en acier au carbone BST-109 miniatures Outils électroniques à main Décapant de câble
8,60€ 9,31€
0
Recommandations
Commentaires (0)
Aresby 14/03/2019
The consistency of this solder paste is like toothpaste, but is grey! It turns into solder with the heat of a normal soldering iron or a hot air gun. Works great for SMD components. Don't use too much, just a smear is enough on modern PCBs and using clean SMS components.
MÉCANIQUE Soudure Pâte à Souder Flux SMD SMT Sn63/Pb37 Fer à Souder Outil de Réparation
8,60€ 9,31€
0
Recommandations
Commentaires (0)
Aresby 05/01/2019
You can use libraries written by others, which usually work well enough, or write your own as all it requires is 5 bytes of data using I2C, very easy to create a fully-fledged radio with an LCD, multiple memory tuning, rotary encoder for manual tuning or just a couple of buttons. An ideal central module for a much bigger, beginners' project.
TEA5767 FM Stéréo Radio Module 76-108MHZ pour Arduino avec Antenne
13,98€ 14,90€
0
Recommandations
Commentaires (0)

Vous êtes l'expert, pouvez-vous aider?

Nous vous invitons sincèrement à vous abonner à l'e-mail d'invitation à répondre!

Si vous vous abonnez, nous vous inviterons par e-mail à répondre aux questions des gens sur les produits. En vous abonnant, vous gagnerez également le «Badge utile»! Vous pouvez vous désinscrire à tout moment sur la page des paramètres de confidentialité.

Aidez les autres et soyez plus heureux!

  • S'abonner

À propos des badges

Les badges sont liés à la communauté et les utilisateurs le font en créant un contenu de qualité, en complétant des missions ou en participant à des activités spéciales. Les personnes spécifiques auront également leur propre badge exclusif.
Badge du PDG

L’insigne du PDG appartient uniquement au patron de Banggood.

Les badges que vous pouvez gagner arrivent bientôt
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe