nullvoxel
mon contenu
Tous les messages
Commentaires
Commentaires
réponses
Questions

Tous les messages

nullvoxel 27/01/2021
awesome torch. gets warm but not hot enough to cause damage to led or make it uncomfortable to hold. careful to not put it down when running, as the light output can burn things from this torch.
Lampe de poche Gray Convoy S2+ SST40 1800lm 5000K 6500K avec Gestion de la Protection de Température Batterie 18650
20,01€ 25,82€
1
Recommandations
Commentaires (0)

nullvoxel Isn'tthe output isolated already?

Jarrodduval 11/05/2020
Arrived with red positive wire disconnected . Re soldered and hot glued.. Really needs better terminal protective wrapping. Pretty much nothing except a nylon sticky wrap. Which really doesn't offer much protection. I suggest you buy kapton tape, and some really high quality electrical tape. Better safe than dead, internally these power supplies store a lot of charge NO JOKE. Finally I wrapped it in car vinyl wrap as the outside casing is earthed. Not saying these are not worth buying . Just be prepared to make it safer to use as a power supply for lipo battery charging. Below are some pictures of the final result. Thankyou
HP Alimentation DC 12V 460W 38A avec prise XT60U-F pour ISDT Q6 Chargeur SKYRC B6 NANO Batterie
34,09€ 35,97€
7
Commentaires (1)
Chargeur de caméra 1080P Mini chargeur USB sans fil Détection de mouvement de caméra 1A Caméra de sécurité à Charge rapide Adaptateur secteur pour appareil photo portable Enregistreur vidéo
25,56€ 24,90€

Q: does this camera work all the time.. recording full time . or just when it detects movement.?

demandé par BG401817433 sur 2021-06-01 07:21:20

nullvoxel both. Move the switch from "L" (loop recording) to "M" (Motion recording) to change between modes.

2021-06-01 08:30:31 Utile (2)
Soumettre
réponses (1)
nullvoxel 10/02/2021
Seems to work well. time will tell if it balances the batteries.
3S BMS 25A 12.6V 4S 16.8V 5S 21V Carte de protection de batterie au lithium Li-ion 18650 Circuit de charge du module PCB de batterie Li-ion polymère Lipo PCM
4,60€ 9,22€
0
Recommandations
Commentaires (1)
nullvoxel 10/02/2021
everything works as described. I would say it can do more then it's rated thickness as it was welding very well at it's rated thickness at power level 3. The USB-C versions charge port is a bit finicky.
1S Mini Poste de Soudage par Points Machine de Soudage DIY Batterie Lithium 18650 Ceinture de Nickel Soudage par Points Machine de Soudage Portable pour la Maison
60,72€ 63,65€
0
Recommandations
Commentaires (1)
nullvoxel 10/02/2021
It's a fuse holder. I don't think anything needs explaining.
HS-912 moyen imperméable à l'eau 16AWG fil en ligne de voiture Automotive Blade Fuse Holder
6,38€ 7,37€
0
Recommandations
Commentaires (0)

nullvoxel itdoes have an auto-detect mode. You enable it by first turning on the device and then single pressing the button.

psychotik2k3 11/07/2020
tested quickly on an AA battery, it worked. in reality the device send the current every 1.5 seconds with a beep, so it does not detect if you have contact or not (i have the mini usb version). but for the price it's cool. only 2 drawbacks are on the solder pins: it seems they are not removable and they are not isolated on a long distance, the distance where you hold it with your fingers... i'm not sure what happens if your fingers are wet... i isolate them with some thermalshrink tubes for safety.
1S Mini Poste de Soudage par Points Machine de Soudage DIY Batterie Lithium 18650 Ceinture de Nickel Soudage par Points Machine de Soudage Portable pour la Maison
60,72€ 63,65€
25
Commentaires (10)
nullvoxel 10/02/2021
Resistors work as expected. The value of them doesn't change when jolted so i would say the mechanical side of them is good. The screw has a nice firmness to it but not too firm.
Kit de potentiomètres trimmer Geekcreit® 10 valeurs 100 pièces 100Ω~1MΩ
11,06€ 17,49€
0
Recommandations
Commentaires (0)
nullvoxel 10/02/2021
buttons work as expected. Great for replacements or prototyping.
100 pièces 10 modèles 6x6 interrupteur tactile interrupteur à bouton poussoir tactile Kit hauteur 4.3 MM-13 MM DIP 4 P Micro interrupteur 6x6 interrupteur à clé
9,58€ 10,14€
0
Recommandations
Commentaires (0)
nullvoxel 10/02/2021
Works well!
Panneau solaire photovoltaïque polycristallin mini 18V 2.5W pour les projets de bricolage
8,52€ 11,06€
0
Recommandations
Commentaires (0)
nullvoxel 10/02/2021
Works well. Adjusted my 18V MPPT to 12.4v for a 3S battery so as to undercharge it for better life.
Contrôleur solaire MPPT 1A 3,2V 3,7V 3,8V 7,4V 11,1V 14,8V Chargeur de batterie au lithium-ion LiFePO4 Module de chargeur de batterie au titanate SD30CRMA
7,74€ 12,91€
0
Recommandations
Commentaires (0)
nullvoxel 10/02/2021
Works well.
5mm / 10mm / 15mm / 20mm / 25mm / 30mm Film polyimide haute température ruban résistant à la chaleur pour imprimante 3D
5,31€ 5,53€
0
Recommandations
Commentaires (0)
nullvoxel 27/01/2021
powerful little torch. does get warm in the hand but not warm enough to cause damage to led or be uncomfortable. be careful of light output as it can burn things on maximum setting, so make sure to turn it off before you put it away or in pockets.
Lampe torche Convoy S2+ SST40 1800lm 6500K avec protection contre la température et support pour batterie 18650
17,70€ 29,51€
0
Recommandations
Commentaires (0)
Extracteur de fumée de soudure 220V avec filtre à air pour la soudure
43,49€ 52,58€

Q: does it work with 230V?

demandé par BlueNath sur 2019-10-15 12:47:14

nullvoxel worksfine on my 240v supply

2021-01-27 12:29:40 Utile (0)
Soumettre
réponses (2)
nullvoxel 06/08/2020
Works well for BGA jobs. Shame it doesn't come with a plunger though.
Pâte à souder KSS S800 10CC pour la pose de SMD Bga sur fils
12,83€ 14,75€
0
Recommandations
Commentaires (0)
nullvoxel 06/08/2020
Great for the price. but it's a little hard to dispense the liquid flux with it.
BON-102 Pâte de flux Stylo à pâte à souder Stylo à flux de soudure
9,58€ 10,14€
0
Recommandations
Commentaires (0)
nullvoxel 06/08/2020
Good value good product works as described solder flows well but cleanup is a little harder then with most fluxes.
MÉCANICIEN MCN-UV80 Flux de pâte à souder sans nettoyage Étain à souder BGA Flux de soudage électrique pour PCB BGA SMD
12,17€ 13,83€
0
Recommandations
Commentaires (0)
nullvoxel 30/06/2020
Fan is a bit loud Quality of plastic is okay for what it is. Don't expect anything super durable. Apart from that, no complaints. Does what it says on the tin.
Extracteur de fumée de soudure 220V avec filtre à air pour la soudure
43,49€ 52,58€
0
Recommandations
Commentaires (0)

Vous êtes l'expert, pouvez-vous aider?

Nous vous invitons sincèrement à vous abonner à l'e-mail d'invitation à répondre!

Si vous vous abonnez, nous vous inviterons par e-mail à répondre aux questions des gens sur les produits. En vous abonnant, vous gagnerez également le «Badge utile»! Vous pouvez vous désinscrire à tout moment sur la page des paramètres de confidentialité.

Aidez les autres et soyez plus heureux!

  • S'abonner

À propos des badges

Les badges sont liés à la communauté et les utilisateurs le font en créant un contenu de qualité, en complétant des missions ou en participant à des activités spéciales. Les personnes spécifiques auront également leur propre badge exclusif.
Badge du PDG

L’insigne du PDG appartient uniquement au patron de Banggood.

Les badges que vous pouvez gagner arrivent bientôt
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe