Meilleures offres pour Épingle - Banggood France Achats en ligne

vyper1

mon contenu: Tous les messages; Commentaires; Commentaires; réponses; Questions

Tous les messages

vyper1 30/01/2019

I wouldn't say they are super loud but I can hear them clearly and that is all that's required.

5 PCS Super Fort 5V Alarme Active Buzzer Traqueur 9*5.5mm pour Drones de Course RC MultiRotor FPV

7,42€ 8,29€

0

Commentaires (0)

vyper1 30/01/2019

Decent enough lipo checker to use at the field and at home for that quick status check. On occasion it's reading up to minus .03 V below the reading my charger or a multimeter gives but this is perfectly acceptable. Only thing I think this is missing, is a back light for low-light situations as the screen isn't the most visible.

3 en 1 2S-6S Déchargeur Testeur de Tension Équilibreur pour Batterie Li-Po Li-Fe

13,26€ 17,70€

1

Commentaires (0)

vyper1 30/01/2019

Good pins with a nice small 90 degree bend

10Pcs Lantian 2.54mm plaqué or 3U inversé courbe connecteur simple en-tête de broche

1,53€ 2,86€

0

Commentaires (0)

vyper1 30/01/2019

This is my 1st quad so I have nothing to benchmark it against. I've done a few flights with it now and for me I think it's a fantastic quad. All I can say with 100% certainty are the things I don't like about this kit. I made the mistake of going to cut the motor wires to the exact length only to find out that it is the worst wire I have come across. Luckily I had only cut one of the wires before I realised not to cut them. There is absolutely minimal room within the frame to mount anything other than a micro RX and when you do fit this then make sure it's well isolated from the frame as it will induce unwanted vibration to the FC. I have installed anti vibration mounts for the FC as well as soft mounts for the motors just to make sure I don't get any erratic gyro behaviour. Even though this is my first quad I did find the camera to be a bad performer especially in low-light and transitioning from light to dark, so I swapped it out for a Foxeer Monster V3. I have managed to squeeze in a buzzer just behind the stack and I have replaced the antenna for a stubby one which is performing just as well as the long one that came with the kit. I have also managed to fit Leds around the quad which helps greatly when I fly LOS, so I would now say this kit is complete. Like I said, this is my 1st quad so I have nothing to compare its performance against but for me I find it a great first timer and it should help me learn at a reasonable cost.

Eachine Tyro99 Version DIY de drone de course FPV de 210 mm F4 OSD 30A BLHeli_S 48CH 200mW VTX Caméra 700TVL

142,78€ 148,52€

0

Commentaires (1)

vyper1 30/01/2019

Good little battery indicator and the fact you can set it for multiple voltages is a real bonus. So I have ordered a couple more for some more projects I'm doing. No instructions but you can figure out how it goes together, I'd suggest you install the bar display before you do the IC otherwise you can't have it flush.

Module d'indicateur de capacité de batterie LM3914, testeur de niveau de puissance avec affichage LED

5,31€ 7,88€

0

Commentaires (1)

vyper1 30/01/2019

Simple motor controller, works perfectly well.

Mini DC 4.5V à DC 35V 5A 90 W DC Moteur PWM Contrôleur de vitesse Module régulateur de vitesse Commutateur réglable

2,23€ 3,31€

0

Commentaires (0)

vyper1 29/12/2018

seems to be decent enough quality and will come in handy.

Modèle de Mesure d'Angle Professionnel Outil de Mesure de l'Angle Rapporteur Multi-Angles Outil de Mise en Page Règle

4,50€ 18,09€

0

Commentaires (0)

vyper1 25/12/2018

Markings are off at the start of the ruler but other than that, they are fine.

1 pièce de règle droite en acier inoxydable de 15 cm des deux côtés pour la mesure métrique argentée

8,52€ 9,22€

0

Commentaires (1)

vyper1 25/12/2018

Used these to bind RX from TX module pins

Pince de test Clip de test de crochet de fil pour analyseur logique

7,45€ 8,29€

0

Commentaires (0)

vyper1 19/12/2018

Not used it yet but I can't see there being any problems. Seems to be a decent amount of windings so should last a while.

0.5mm 63/37 fil à souder au plomb étain noyau de colophane à souder 2% Tube de bobine de Flux

2,66€ 2,91€

0

Commentaires (0)

vyper1 19/12/2018

Slight issue with the fact that the ruler doesn't start at 0. The 1st mark is about 1.5mm in size. Once you take that into consideration then you'll make no mistakes. They come in individual sleeves which is a bonus.

1 pièce de règle droite en acier inoxydable de 15 cm des deux côtés pour la mesure métrique argentée

8,52€ 9,22€

0

Commentaires (1)

vyper1 18/12/2018

Not put them to test yet but all cells balanced and they seem to be in good order. Hopefully they work as expected.

Batterie Lipo ZOP Power 11.1V 1500mAh 40C 3S avec prise XT60 pour Eachine Wizard X220 FPV Racing RC Drone

21,21€ 24,90€

0

Commentaires (0)

vyper1 18/12/2018

I've built 5 of these and all have worked perfectly. My only gripe is they switched the power button and I'd prefer if these were micro usb powered instead of the barrel.

Kit de sapin de Noël LED Flash de Geekcreit®, kit électronique 3D d'apprentissage DIY

8,48€ 12,91€

0

Commentaires (0)

vyper1 18/12/2018

Only time will tell to see how long they last.

DANIU Pince coupante électrique pour câble Coupe-câble Pince coupante diagonale Pinces d'ébarbage Outil

9,22€ 11,98€

0

Commentaires (0)

vyper1 18/12/2018

but does not work, red leds remain very dull and the aren't much better. There is no flashing so i think there's an issue with the IC

Geekcreit® DIY Effet Etoile LED 3D Kit Arbre de Noël Décoratif

6,67€ 7,37€

0

Commentaires (0)

vyper1 18/12/2018

USB boards, perfect for my build.

5pcs Micro USB à douille femelle dip de type B Microphone 5P Patch à Dip 2,54 mm Pin avec carte d'adaptateur de soudage

7,42€ 7,37€

0

Commentaires (0)

vyper1 18/12/2018

It cleans your tip.

1PC Nettoyeur de pointe de fer à souder lourd en fil d'acier Fournitures de soudure

8,29€ 13,83€

0

Commentaires (0)

vyper1 18/12/2018

It solders things together.

50g 0.5/0.6/0.8/1.0mm 63/37 FLUX 2.0% 45FT étain plomb fil d'étain fondre colophane noyau soudure fil à souder rouleau

9,58€ 10,14€

0

Commentaires (0)

vyper1 17/12/2018

Used mainly for sticking down Frsky RX to quadcopter and it does the trick.

Ruban Adhésif Forte Permanent Double Faces 3Mèrer Rouleau de Ruban Super Collant Pour Véhicule

4,60€ 5,53€

0

Commentaires (0)

vyper1 16/12/2018

To start with, I have large hands but this form factor suits me ok and I don't have any issues with its smaller size. The buttons for open tx menu navigation are a bit unintuitive but after a while you get used to it. The gimbals seem fine and precise enough and the only thing this transmitter is missing is a momentary switch but overall it is a good TX and worth the money. My only true gripe is the bind process for some of the protocols you only get 2 or 3 bind chirps and dependent on the RX you are binding too,especially if it's one you have to start bind on TX then hold button on RX as applying power to it, then sometimes 2 or 3 bind chirps is not enough time. If this can be increased then please let me know. I'm also struggling to find a 2S lipo that will fit the battery compartment as this TX will eat through AA and NiMH in no time. But, overall I'm pleased with this Jumper T12 and only time will tell to see if it will stand the test of time.

Jumper T12 Émetteur radio OpenTX 16CH avec module RF multi-protocoles JP4-en-1 pour Frsky JR Flysky

84,68€ 97,43€

0

Commentaires (0)