Tous les messages

Eduard Thisis a controller board. You can replace the Ender 3 Pro controller with this one and flash the firmware with MARLIN 2.0.

2020-12-25 02:53:35 Utile (0)
Soumettre
réponses (1)

Eduard Ihave not tested this myself, but I did do a lot of research. It seems everyone struggles with range, search for "built-in error correction" code. The Antenna must be stretched as far as possible away from the device, and remember don't point the antenna's towards each other, they must be parallel. There is also a potential issue with the 0603 capacitor, another commenter wrote something about it.

2020-12-25 02:51:48 Utile (0)
Soumettre
réponses (1)