mszulen
mszulen Look at the balancer connector. It does not get the full 6s voltage. It's made to get 3s only from the connector. You could use it even on 10s :)
2023-09-12 10:02:24 Utile (0)Q: Hi, how many power does th battery have. I was just wondering.
demandé par BG141516153 sur 2022-12-15 04:10:53
mszulen If you're asking about the battery capacity - it's 2s, 1000mAh
2022-12-15 04:23:45 Utile (0)
Q: how much amperes esc for edf 40mm 8000kv merci
demandé par BG241522520 sur 2022-05-12 10:09:08
mszulen 30A is enough
2022-05-16 03:22:03 Utile (0)
Q: Does it come with 32 or 8 bit version of motherboard ?
demandé par BG421649144 sur 2021-10-17 05:15:31
mszulen I've got 32bit 4.2.2 board (which I already swapped for SKR E3 Mini V2 :) )
2021-10-18 08:58:53 Utile (0)
mszulen The rail i strong enough. On the other hand - check if you're not getting cured resin in the corners. This is known issue with this printer (light bleeding). It is NOT related to the build plate being warped. It's due to too high voltage set for the UV light. This can be set with the potentiometer in the power supply section.
2021-04-29 03:06:43 Utile (1)
mszulen 30A is more than enough
2020-10-17 11:15:50 Utile (0)
Nous vous invitons sincèrement à vous abonner à l'e-mail d'invitation à répondre!
Si vous vous abonnez, nous vous inviterons par e-mail à répondre aux questions des gens sur les produits. En vous abonnant, vous gagnerez également le «Badge utile»! Vous pouvez vous désinscrire à tout moment sur la page des paramètres de confidentialité.
Aidez les autres et soyez plus heureux!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
mszulen You mean an inrunner vs outrunner? The Inrunner (the case with Freewing) is easier to install. Check if your motor has threaded holes in the back (if yes - it's even easier to install). Otherwise you can use zip ties to the back of the motor (INRUNNER ONLY) via the cooling holes.
2023-09-12 10:07:45 Utile (0)