rpogorelc
- mon contenu
- Tous les messages
- Commentaires
- Commentaires
- réponses
- Questions
réponses
Q: Does this board have an i2c connection for compass to use with gps?
demandé par BG415170181 sur 2020-09-07 08:59:44
Q: 4 pin connector provided doesn't fit gps module. What do i do?
demandé par JordanWest sur 2020-08-09 11:05:57
rpogorelc You need a JST-SH 1.25MM Cable of whatever length you need, or just search for Beitian BN-220T replacement cable
Utile (0)
Q: the description mentions is has 30x30 mounting holes. is this correct? it looks like 20x20 and 25x25
demandé par Rovadevel sur 2020-08-13 10:37:25
rpogorelc I suppose you can do all 3. I'll put a pic in my review so you can see what I mean. You would have to use longer screws than they come with to do 30.5, since they come with short ones to fasten the arms through the press nuts. You do have holes for 20mm and 25.5mm.
Utile (1)
Q: Can I mount this board? 25.5x25.5mm JHEMCU GHF411AIO F4
demandé par risko sur 2020-08-16 17:15:43
rpogorelc I suppose you can do all 3. I'll put a pic in my review so you can see what I mean. You would have to use longer screws than they come with to do 30.5, since they come with short ones to fasten the arms through the press nuts. You do have holes for 20mm and 25.5mm.
Utile (1)
rpogorelc It doesn't include a receiver. You do have to solder the motor wires.
Utile (0)
Q: How many Chinese Amps equal one international standard Amp?
demandé par discord sur 2020-07-28 02:19:31
rpogorelc CopperTopfpv, I know you were joking, but I decided to be the first to buy one, No crazier than buying a Crazybee. We know they will fail.
Utile (0)
Q: Will the Crossfire receiver work with the new TBS Crossfire Micro TX V2?
demandé par BG163104618 sur 2020-07-21 13:11:28
rpogorelc Yes, it's only Frsky that likes to screw their customers.
Utile (0)
Q: Where on this board is UartRX1? UartTX1 has its own pad but RX1 cannot be found...
demandé par BG644165463 sur 2020-06-27 06:15:25
rpogorelc TX1 is intended for SmartAudio. They didn't break out the RX1 pad because you couldn't use it anyway if you use TX1 for it's intended purpose. If you need a full UART for say Crossfire, use the pads towards the center RX2 & TX2 for that.
Utile (1)
rpogorelc Where exactly? I don't see one anywhere.
Utile (0)