Raqtor
- mon contenu
- Tous les messages
- Commentaires
- Commentaires
- réponses
- Questions
réponses
Q: Can you put it next to the X6B receiver from flysky? (I mean on the same level of the stack)
demandé par Fufs sur 2018-09-29 13:11:05
Raqtor This is bigger than a half stack so you would need a bit level height difference.
Utile (0)
Q: Is the receiver flashed to get RSSI in the OSD?
demandé par windwarrior sur 2018-09-01 09:30:29
Raqtor Nah. All reviews I have seen says it isn't ..
Utile (0)
Q: Does it support 6s batteries?
demandé par Fiene sur 2018-07-17 08:31:54
Raqtor Nope .. 7-24V 6S is over 25V already without any power spikes and without it being HV battery
Utile (0)
Q: What kind of connector I need for the motors? Mine do not have Connector. Thank You!
demandé par jrtrudel sur 2018-01-09 02:05:11
Raqtor That really sucks since all motors comes with 1.25mm JST Plug. Does any motor with SH1.0mm even exist?
Utile (0)
Q: Did anybody tried to connect TBS unify SmartAudio on the GPS TX pad ? I need at a second UART !
demandé par nico2nice sur 2017-11-24 10:23:59
Raqtor Should work using TX6 to the VTX control and setup smart audio on UART6 in betaflight .. Have you tried it yet? .. Otherwise resource remapping should allow you to use the LED strip pad for VTX control instead.
Utile (0)
Q: which Uart is the esc telemetry connected to?
demandé par Zak sur 2018-01-19 07:20:31
Raqtor Hi Zak. Did you figure it out? .. I am interested in this too .. Is ESC telemetry even connected?
Utile (0)
Raqtor No! Only a camera. Current rating is not even documented so don't expect it to do more than that. ... 6S might be starting to trend tho I have never seen a 6S yet. If you run 6S you just need a voltage step down to preferable 9V or so
Utile (0)