Anton
- mon contenu
- Tous les messages
- Commentaires
- Commentaires
- réponses
- Questions
réponses
Q: Lag? Can this camera be used for FPV, to pilot a race quadcopter in rate mode?
demandé par eric.brasseur sur 2019-04-08 02:43:29
Q: Hello Camera is going to heat up too much. I use 3.7 300mAh Battery what reasons is that?
demandé par Shahid sur 2019-05-23 10:37:40
Anton The camera worked fine for a long duration @ 25mW on the bench test. When flying, the air movement should keep the unit cool enough. These cameras all typically get rather hot.
Utile (0)
Anton Yes, so long as the connections are right. I recommend this small unit with volume control 1068215
Utile (0)
Q: can I power two 5 watt spekars with this board?
demandé par Rishabh Sharma sur 2019-01-13 12:33:14
Anton No, not directly but you can use a PAM8403 type amplifier in addition.
Utile (1)
Q: Can I connect 2×5watt 4ohm speaker
demandé par ghoshsubha79 sur 2019-01-09 23:26:36
Anton You can, but the volume will be barely audible as this has headphone level output.
Utile (0)
Q: How many watts of power does it output per channel?
demandé par AdamRoemer sur 2018-09-29 01:12:15
Anton Microwatts. This will NOT drive speakers directly. Used for driving headphones or or an EXTERNAL amplifier.
Utile (0)
Anton I've found this to be too laggy for FPV whoop flying, but it's OK for a slower craft. Main issue is the transmitted framerate drops to about 15fps when recording (it auto-records which is nice), and 25/30 when not. The upside is that the recorded videos are 720p direct from the sensor and not analogue, then converted to digital.
Utile (0)