Langue
Livrer à 
United Kingdom , USD
United Kingdom , USD
United Kingdom , USD
Eachine QX65 avec caméra 5.8G 48CH 700TVL F3 intégrée OSD 65mm Micro FPV Drone Quadcopter
80,39€
83,89€
View It
123 Change the receiver's protocol from SPEKTRUM2048 to SPEKTRUM1024
Répondre 04/02/2018
Tatjana Leto You have to setup your transmitter from 1000-2000 otherwise it will nont arm.
Répondre 07/02/2018
highks Maybe there is a throttle-cut programmed for one of the switches? You\'d need to disable the throttle cut to start the motors. You can look at the programming of all the switches by connecting the quad to betaflight.
Répondre 08/02/2018
highks You need to flip the arm switch in order to get the motors spinning. Don't know where that switch is on this quad or on your transmitter, but you can look it up in betaflight.
Répondre 12/02/2018
borvanbeers Did you arm the quad? Google on how to do this if you haven't already armed it.
Répondre 15/02/2018
Jesse Have you configured it in Betaflight? You may need to connect it to your computer and change a few settings?
Répondre 18/02/2018
Klaus_R same problem here; learning a lot about deviation and betaflight - but obviously not enough to program an arming switch on my TBSG :/
Répondre 19/02/2018
redfactorman there is a youtube video that covers connecting a DSM2 in betaflight.
Répondre 22/02/2018
AdrianD90 Have you changed the arming sequence in betaflight to a switch and checked for low throttlejQuery19106909420793233754_1519818236483
Répondre 28/02/2018
Fernando I had trouble arming until I lowered the throttle trim
Répondre 16/03/2018| Notre Société | Contactez-nous | Paiement & Expédition | Programmes De Partenariat |
|---|---|---|---|
