Module GPS BN-800 supporte GPS GLONASS BeiDou pour Pixhawk APM
Une partie de la critique a été traduite automatiquement.
From what I read in the ublox manual and how this receiver behaves, it is a M8M and not an M8N. Also there is no "EXT CORE 2.01" message on boot which would be expected from an M8N but not an M8M. The difference is that the M8M version does not have nonvolatile flash memory to store the configuration. The receiver only stores settings in On-chip BBR (battery backed RAM) which lasts as long as the installed battery, certainly not over night if switched off. Although the systems runs very nicely, I can only give two stars for quality with this seemingly being not the product announced.
Lo compre ya que tenia problemas con el gps de serie del cheerson cx20. Este me impresionó, muy rapido en detectar satelites, ahora estoy dentro de la casa desde el MP y me detecta 14... muy por encima al que tenia el cheerson. Compra recomendada
Works with GlonaSS and GPS. has standard 30x30 mounting holes. Gets easy 21 sats!
Отличный GPS, ловит и GPS и Глонасс Покупаю уже второй такой
Нужен был GPS для квадракоптера с монтажом на стойки - этот вариант подошел отлично.
Just installed this on my Pixhawk Lite - had to pull the pins from the connector and insert them into the plastic plug of the Pixhawk Lite as the plug supplied with the GPS was not compatible at the flight controller end, but this is something drone builders are used to. The signal I get from this is truly staggering. 17 Satellites within a 3 minute cold start at first power up (connected to U-Center with FTDI adapter). After installing in my FX-61 Phantom, and powering up, I got 17 satellites within 30 seconds on a warm start, and this was indoors with HDOP of 1.0. I haven't yet tested it outside but with this signal level indoors it's got be pretty good. I have bought GPS receivers three times this price which weren't as good. This is on par with the Beitian BN-880 which is aslightly smaller but thicker, with same components. I have one on my Tarot 680 Pro hexacopter which gets perfect satellite signal also. Very happy with this purchase.
Упакован был в паралонку. Пришёл без повреждений. Подключил к пк через ftdi пока запускал u-center он успел определить позицию. 9 спутников hdop 1.6 на подоконнике gps + glonass скорость 38400 протокол nmea. Конфигурацию менять не стал попробую на pixhawk как себя поведёт. Шоейф в комплекте 6 pin с обоих сторон его придётся переделать.
I got this as a replacement GPS for my Quanum Nova / Cheerson CX-20 because I killed the original one. This one has a build in compass, you need to build a wire to your GPS Port and to your I2C Port by yourself because the supplied one does'nt fit on any Flightcontroller I know. But if you have made a working cable It works like a charm, I get up to 20 sats (old GPS had maybe 7-10) and a HDOP down to 1.0 wich is crazy accurate. It would be nice if the cable supplied would be useable, at least a DF13 connector would be great :) everything else is just great and for this price it is just incredible.
3.01 firmware, glonass, galileo compatible. Cool that it can be mounted in the fc 30.5x30.5 stack. Soldering pins not showed on Bg pics. 8 sats near window. Recommend.
Swopped the original rev A GPS on my 3DR Solo to a BN-800 dual constellation GNSS. Now receiving both GPS and GLONASS satellites simultaneously. Seemed to hold position better now. Just need to rewire, no change to default settings.