Para repuesto impresora Anet A8, buen aspecto

Para repuesto impresora Anet A8, buen aspecto

Para repuesto impresora Anet A8, buen aspecto

llego perfecto para mk8 tevo tarantula

llego perfecto para mk8 tevo tarantula

llego perfecto para mk8 tevo tarantula

Object as described.The object looks well done.

Object as described.The object looks well done.

Object as described.The object looks well done.

I am satisfied

I am satisfied

I am satisfied

can’t go wrong with some spares will use them when i get around for my carbon fiber filament

can’t go wrong with some spares will use them when i get around for my carbon fiber filament

can’t go wrong with some spares will use them when i get around for my carbon fiber filament

Nice finish 3D printing nozzle diameter 0.4mm. Very sharp tip, there is hardly any surface around the hole to squeeze the plastic flat. Not tested in printing jobs yet. I wanted to put this on my anet A8 but I fear due to the small body of the nozzle it will not be very temperature stable when printing at higher speeds.

Nice finish 3D printing nozzle diameter 0.4mm. Very sharp tip, there is hardly any surface around the hole to squeeze the plastic flat. Not tested in printing jobs yet. I wanted to put this on my anet A8 but I fear due to the small body of the nozzle it will not be very temperature stable when printing at higher speeds.

Nice finish 3D printing nozzle diameter 0.4mm. Very sharp tip, there is hardly any surface around the hole to squeeze the plastic flat. Not tested in printing jobs yet. I wanted to put this on my anet A8 but I fear due to the small body of the nozzle it will not be very temperature stable when printing at higher speeds.

Muy buen producto, Gracias BANGGOOD.

Muy buen producto, Gracias BANGGOOD.

Muy buen producto, Gracias BANGGOOD.

The surface at the bottom of the nozzle is very smal so your filament has less chance to stick to the bottom side .always check the diameter of the nozzle hole to make sure your settings are right.

The surface at the bottom of the nozzle is very smal so your filament has less chance to stick to the bottom side .always check the diameter of the nozzle hole to make sure your settings are right.

The surface at the bottom of the nozzle is very smal so your filament has less chance to stick to the bottom side .always check the diameter of the nozzle hole to make sure your settings are right.

Délivré rapide, bon vendeur!!

Quick delivred, good seller !!

Délivré rapide, bon vendeur!!

très bien

très bien

très bien