Meilleures offres pour Arbre de transmission de voiture RC,Pièces de voiture RC

demandé par Happless sur 2020-09-28 04:29:56

Sushijjgg99 110mm is total end to end length

2020-10-02 04:43:11 Utile (3)

Soumettre

réponses (3)

FS-RX2A Pro V1 2.4G Récepteur Compatible pour FS-I6 FS-I6X Émetteur FS-I6S FS-TM8 FS-TM10 FS-I10

17,32€ 18,75€

Q: Will this transmitter work on a Racerstar StarF4S 30A Blheli_S Dshot 4 in 1 ESC AIO F4 OSD Flight Controller w/ BEC Current Sensor?

demandé par BG575250164 sur 2021-01-25 10:11:08

Happless Yes it appears these 2 will work. Just need to use the rx6 pad on the board for the IBUS line

2021-01-25 10:15:50 Utile

Soumettre

réponses (1)

Hobbywing EzRun Max8 v3 150A ESC étanche sans balais avec moteur 2200KV pour pièces de voiture RC 1/8

223,14€ 232,59€

Q: would this be a good motor combo for a zd racing pirates 3 roller chassis

demandé par BG231491431 sur 2020-06-28 11:06:20

Happless This is pretty much the same setup I run on that chassis. I would say one thing, you will NEED the wheelie bar. It is devastatingly hilarious the ease with which this setup will make make my Monster Truck wheel stand.

2020-10-01 11:23:11 Utile

Soumettre

réponses (3)

ZD Racing 9021 V3 1/8 4WD 80km/h Kit châssis de voiture radiocommandée sans pièces électroniques

271,98€ 301,99€

Q: Can I purchase a wheelie bar for the 9021. espoiler is currently being used as one. any suggestions?

demandé par Kyle Bock sur 2020-06-28 11:56:12

Happless You could go the ZD racing one, but then you gotta replace your RR lower suspension mount and replace it with plastic one on wheelie bar. Better bet would be one like the BSR Berserker uses.

2020-10-01 12:36:46 Utile

Soumettre

réponses (2)

Happless 14/08/2018

So I have been thrashing with this thing for a few weeks now and ultimately I am pretty damn happy with it. However, that does come with some caveats. First when I originally received it both front and rear differentials were binding badly. After some investigation I found that when they had been assembled the crown gears had not been torqued down evenly, so as a result they were not flat relative to the diff case. This also resulted in the gaskets being deformed and the diffs leaking. Luckily for me I was able to replace them with my own gaskets by making a cutting guide and cutting new ones out of gasket paper. Also possibly due to sub par, or non-existent packaging (it just came in a cardboard box with no packaging that showed the rigors of international shipping) the left rear shock was badly damaged. The thread on the retaining nut for the damper plate was completely stripped. Again I have been able to fix this. I did contact banggood CS about these issues but at time of writing have still received no reply. So in closing, if you are willing, able and prepared to have to totally strip the drive line down on receiving it, this is a great truck for thrashing. Be warned it will wheelie at the drop of a hat, but this is part of it being a monster truck to my mind.