Tous les messages

BG443624209 Attention ! My welder stopped welding. if you have this happen. Disassemble the mig welding handle and check if the cable is attached, to the pole shoe. If not that is the very problem for not welding ! it's a bit fiddly to take apart. Do not break the gas line nipple and check it for leaks. I had to retorque with pliars on assemby. The feed wire nut is 10 mm u- block key. do not break the gas hose nipple! . The pole shoe hole which is crimped, i had to enlarge with a tool and cut open. I refitted the cable and used pliar to fold back the tabs. Then i soldered the cable with a 100w soldering iron. Do no use to much solder or it will be hard to fit behind the nut. It is a very good welder otherwise.

BG443624209 10/06/2022
1
Commentaires (2)