Avis des clients

Ecrire un commentaire
  • Tous les Commentaires (791)
  • Image (88)
  • Vidéo (6)
  • Toutes les Étoiles
    • Toutes les Étoiles(791)
    • 5 Étoile(774)
    • 4 Étoile(11)
    • 3 Étoile(5)
    • 2 Étoile(1)
    • 1 Étoile(0)
Trier par:
Commentaire Top
  • Commentaire Top
  • Le plus utile
  • Le plus récent
Avis uniquement de votre pays (France)
|
Afficher l'original

Une partie de la critique a été traduite automatiquement.

  • 06/09/2017

    I have this fitted and working well in my 450ish sized custom built drone. It's connected to an Omnibus F3 board running Inav. I have just cut the wire connectors off and soldered it to a spare Uart on the FC. Not much info out there on which wire is which but I eventually found that if you take the thing apart the wires are labeled on the PCB. Mine is: R=5v, Blk=GND, Y=TX, W=RX, G=SCL and B=SDA. Make sure you connect the GPS TX to the FC's RX and GPS RX to the FC's TX. Hope this helps someone

    Commentaires (1)
    Afficher l'original
  • 08/01/2016

    Nach nur 14 Tagen mit standard Mail habe ich das GPS erhalten und auch sofort getestet. Wollte dies mit meinem APM 2.6 benutzen. Auf kopterforum.at habe ich gelesen, dass das M8N erheblich besser sein soll, als das 6/7N. Der GPS Stecker paßt nicht an das APM. Baufom und Kontaktabstand ja. Aber es ist eine Kammer zuviel und die GND Leitung (sw) ist in der falschen Kammer. Das war mir aber klar, da dieses hier angebotene GPS Modul für den Pixhawk FC bestimmt ist. Aber auch am APM kann man dieses GPS betreiben. Wie ? Ganz einfach. Mit einer dünnen Nadel die GND Leitung entfernen. Eine Kammer des Steckers mit dem Cuttermesser abtrennen und die GND Leitung in die äußerste nun freie Kammer stecken. Der Sat Fix geht in unter 30 Sekunden nach einem Kaltstart und es werden auch in der Wohnung 6-8 Sats empfangen. Der HDOP Wert ist unter 2. Draußen sind ja nach Witterung zwischen 10-15 Sats normal. Bin sehr zufrieden und kann dieses GPS weiterempfehlen.

    Commentaires (1)
    Afficher l'original
  • 07/04/2016

    EN: Excellent product - it works immediately after connecting to APM (required to adjust the plug from the 6 pin to 5pin). Outside, he found 17 satellites, both the USA and RUS. The magnetometer works very well, the arrow on the housing indicates the correct direction of mounting the entire antenna (front of drone) PL: Doskonały produkt - działa od razu po podłączeniu do APM (wymagane dostosowanie wtyczki z 6 pin na 5pin). Na zewnątrz znalazł 17 satelitów, zarówno USA jak i RUS. Magnetometr działa bardzo dobrze, strzałka na obudowie wskazuje poprawny kierunek montażu całej anteny (przód drona)

    Commentaires
    Afficher l'original
  • 11/04/2016

    Using this GPS with Flip32 without any problem. You just have to remove the build-in compass. In iNav i had to use CW280FLIP to make the compass work properly

    Commentaires
    Afficher l'original
  • 31/01/2018

    Both GPS and Magnometer are tested with ESP32 and Arduino Mega2560. Indoor test: GPS connected to 12 Satellites in less than m. But with built-in HMC5883l sensor wasn’t lucky so far compass error is ~50 degree. Have to find way to compensate offset or to calibrate it. Overall highly recommended!

    Commentaires (1)
    Afficher l'original
  • 21/06/2017

    20 satellites fix in less than one minute. Works flawless with inav. NOT upgradable

    Commentaires
    Afficher l'original
  • 07/02/2016

    I bought this GPS / MAG combi for my FLIP32 flight controller, being aware that the connectors won't fit out of the box. After crimping JR plugs (instead of the supplied Molex) it worked right away. Cable colors / pinout and JR connector setup see my fotos... Cleanflight FW found the GPS module in a second, the MAG as well. Within 60s after the 1st start it found 5 sats on my workbench, I never had this kind of quick sat recognition with any other GPS module before - really great! TOP module - I will just buy another one to replace older NMEA modules...

    Commentaires
    Afficher l'original
  • 19/02/2016

    I am new to this, and my first APM flight was erratic. GPS works great. Compass works great, once I realized it is mounted upside down and that I had to set the Roll value in Mission Planner Compass to ROTATION_ROLL_180 it worked fantastic. VERIFY YOUR COMPASS headings before first flight. If you plan on using this with the APM you do need to switch the connectors. Other reviews detail this, while others say it will work fine (it will once you change the connector)

    Commentaires
    Afficher l'original
  • 06/08/2017

    I have this mounted on my top plate, not a mast. The GPS is SPOT ON. The magnetometer, not so much. It would probably prefer a boom, but INAV has RTH'd 8/8 times successfully in test runs, so no complaints!

    Commentaires (1)
    Afficher l'original
  • 27/04/2017

    This GPS is excellent. I currently have it set up on a quad running a FLIP32 Omnibus F4 and iNav and it has been rock solid. I have already bought a 2nd one to put in my Wing Wing Z-84 :D

    Commentaires (1)
    Afficher l'original
Show:

    Total 0 pages

    Aller à la page

    Vous pourriez être intéressé par

    recommendation for you
    • 27,53€
    • 33,04€
    • 16,79€
    • 29,37€
    • 4,54€
    • 8,25€
    • 18,35€
    • 6,35€
    • 126,69€
    • 9,53€
    • 5,50€
    • 10,56€
    • 6,74€
    • 11,56€
    • 41,64€
    • 11,93€
    • 5,27€
    • 10,55€