Une partie de la critique a été traduite automatiquement.
Un excellent produit
I was able to mount this directly to my Ender 3 V2 stock mount using 2X 25MM M3 screws by tapping then drilling out paths in the top fin of the heat sync. I did this by removing the stock hot end and using it to center the screws and using spare M3 screws to tap the Heat sync. I then drilled out the paths using the tap as a guide. I was also able to transfer the Ender hot end and heat break as well. I didn't use any of the electronics. You will need to print a custom fan shroud. As for the parts, nothing premium here. All basic cheap parts but made with precision. I cant speak for the electronics. Side note, There is a custom PTFE insert called a throat I think. It would be great if Banggood sold spares. It is a 7mm to 4mm OD reducer that funnels the filaments into the hot end. The 2 in 1 out version also has one, but it's shorter.
est venu parfait
L'article est arrivé en toute sécurité et à l'heure, l'emballage a été un peu endommagé mais le four n'a pas été endommagé. la qualité est bonne bien que je n'ai pas encore installé l'unité mais ne vous attendez pas à des problèmes.
Pas encore essayé mais sera mis à jour quand je l'ai utilisé, mais la qualité c'est vraiment bon, mieux que je pensais pour être honnête. Faites l'essai au vendeur...
recommande vivement
3rd class service by banggood . after 10 time conntrack 100 days to resive
J'ai hâte d'utiliser mon extrudeuse 3 en 1! 😀😃
parfait ne peut pas betterave ce
exelent