Pâte de régénération de pointe de soudure électrique AT-6X
Une partie de la critique a été traduite automatiquement.
I previously wrote how much I liked this tip cleaner, since it was much like the RadioShack stuff that is no longer available. One drawback I discovered later was that the cleaner material is a loose powder. This works well, unless you're clumsy like me and tip your rig over from time to time. Then you have a mess. The RS stuff was a solid mass you dipped the solder tip into so was almost non-spillable. I reordered another tin of tip cleaner. This time, I took the top off, set it in a disposable aluminum pie pan, and heated it to 240 F for 2 hours. To be honest, an hour might be long enough. I ran t5he exhaust fan but noticed no odors. When the tip cleaner cooled off, it was formed into a solid mass and isn't spillable. Here are three pics of the material after it comes out of the oven, how the tip is sunk into the tip cleaner to clean it as it melts around the tip, and finally the nice clean tip that results. But it doesn't spill in this format!
Le produit correspond à la description. La qualité est très bonne. Fonctionne très bien. Je l'ai testé et suis très satisfait de ce produit. Le produit a été placé dans un emballage fonctionnel. Le produit i est fortement recommandé.
Il fait son travail parfaitement, nettoie correctement la montagne de paons polluée et corrodée.
ok
Very good product, to clean oxidized soldering iron tips, just dip the hot tip in the refresher and leave it there for a few seconds than the tip will be good as new.
Boîte de poudre pour le nettoyage de la pointe de soudure commandée. Après avoir testé voir la photo, je peux conclure qu'elle remplit son but sans aucun problème. La pointe chaude est nettoyée des résidus d'étain lorsqu 'elle est imbriquée, et le reste est essuyé sur un cube de bois. Très bien, je le recommande.
Très bon produit il a vraiment restauré la pointe. Au début, je pensais que ça ne marcherait peut-être pas si bien que ça, mais ça l'a fait.
Livré selon l'annonce.
Good
This is quite a small tin; 4cm in diameter. I suspect its a mix of powdered tin and flux. Directions: carefully clean your hot soldering iron tip and then push into the tining compound to form a pool. You may need to repeat this several times until the tining compund sticks to the iron tip. But does work.