Reviews des clients

Ecrire un commentaire
  • Tous les Commentaires (234)
  • Image (37)
  • Vidéo (1)
  • Toutes les Étoiles
    • Toutes les Étoiles(234)
    • 5 Étoile(219)
    • 4 Étoile(13)
    • 3 Étoile(2)
    • 2 Étoile(0)
    • 1 Étoile(0)
Trier par:
Commentaire Top
  • Commentaire Top
  • Le plus utile
  • Le plus récent
Avis uniquement de votre pays (France)
Afficher l'original

Une partie de la critique a été traduite automatiquement.

  • 09/02/2021

    Beaucoup plus vite que prévu ! courir sur un pignon 24T dans mon 10 ans Traxxas Slash 1/16. J'ai essayé un LiPo de 1500mah 2s et l'esc était à peine chaud par la suite. J'ai un 3s 25C LiPo à venir bientôt.

    Commentaires (2)
    Afficher l'original
  • 22/09/2021

    Je l'ai acheté afin de mettre à niveau mon mini erevo de brossé à brossé, d'abord vous devez acheter plaque de moteur, monture de moteur et de couvrir, puis raccourcir l'arbre de moteur. Avec 2s éperon de stock et pignon de 28 dents il n'y a pas une grande différence par rapport au titan 550, mais la vitesse est livrée avec 3s, espérons que le moteur et l'ESC tiendront.

    Afficher l'original
  • 28/05/2021

    muy buen combo el motor es muy potente el esc se calienta mucho espero que dure bastante ,se la puse a un zd racing apenas le quedó el motor en el chasis

    Afficher l'original
  • 09/03/2021

    Ça chauffe trop vite. Je crois que je vais échanger l'escale contre une plus grosse.

    Afficher l'original
  • 21/11/2017

    great motor and esc. but maybe the esc is not you expect from the 35A esc. in compare to real 35a esc I have 2 pictures which one a real 35a with soldering board and 18 smd and this esc with normal board and just 9 smd..the wire is thin and the board is too much small. the heat sink came hot easy. I think you must put a fan on this and stay on 2 cell's. but overal is great. thanks banggood.

    Commentaires (3)
    Afficher l'original
  • 25/01/2018

    Pluses: i bought this combo instead of devective standart esc (which shoked after 15 seconds of working) of my FEIYUE FY06 - it works normal, but i can't compare with something else, because this is my first RC car and I was not able to try standart esc Minuses: this esc doesn't have special button for calibration throttle range! very very short wires with power button and t plug connector There was no 2 male screws to connect motor to the frame, so I had to find them at home (screws from standart motor were too small for this motor)

    Commentaires (1)
    Afficher l'original
  • 19/05/2018

    el motor encaja perfectamente en el wltoys a949a959... tiene un tamaño y una potencia perfecta le puse un ventilador para refrigerar el variador el coche ahora vuela!!!!!!

    Afficher l'original
  • 25/03/2017

    Motor works well and seems well made. Esc is also good. Motor weight 117g, shaft size 3.0mm. Shaft extends 15mm from body and has flat side for most of that length. Motor can length 47mm X diam 28mm. Mounting screws are 3mm (not supplied) and go into the case by 4mm so you can work out what length mounting screw to use. I bought a Walkera Master CP heatsink for it, it fits perfectly, a snap on fit ( part no. 925849) weighs only 8g and is anodised nearly the same shade of blue as motor, see attached photos. ESC weighs 34g. Worth buying

    Afficher l'original
  • 03/04/2017

    a nice set of 35A ESC (u want Amps for a 3S lipo setup) and a nice pushy motor. using in in many cars from 1:18 up to 1:12, but would say for 1:18/16 this motor is way overpower (stay smaller 244x better). Keep it on 2s and it's managable with traction control. A 3s setup if posible to drive on 1:12 scale - and there this motor fits perfectly. On photo a Remo with this motor, but it's way to hard to drive, stock shocks are good only for brushed motor, not this BL; same with plastic floor :/ way 2 much flex there - car swims on road like hell when over 60% throttle. will put that motor/esc it in somth. bigger most likely another Feiuye 1:12 mod

    Commentaires (1)
    Afficher l'original
  • 23/12/2018

    This motor esc combo is great value for money. It plenty of torque for its size. The esc does get pretty hot after a few minutes of running, maybe a small cooling fan might reduce tge temps.

    Afficher l'original

    Total 0 pages

    Aller à la page

    Vous pourriez être intéressé par

    recommendation for you
    • 29,85€
    • 52,20€
    • 36,44€
    • 9,12€
    • 57,13€
    • 36,44€
    • 37,86€
    • 9,84€
    • 21,67€
    • 4,91€
    • 20,68€
    • 14,77€
    • 32,36€
    • 45,31€
    • 28,99€
    • 56,14€
    • 160,32€
    • 61,07€